Comments on: Single Lock Locker Box Using a 40MM Ammo Can

By: SSgt. Doug

SSgt. Doug — Wed, 11 Jan 2012 23:04:42 +0000

Good stuff. I haven’t learned to weld yet, but I can drill holes. I can probably use this project to make some secure cases for sealed lead-acid batteries to use with trail cameras and their infrared flash extenders.

Thanks, from a Vietnam-Era USAF cop (E-5).

By: Ranger G (of the forest type)

Ranger G (of the forest type) — Sat, 19 Nov 2011 16:34:02 +0000

Bless you for your service and for a spot-on solution to my perpetual Jeep problem of, “I have something to bolt on and need more space and I THINK I have a couple square inches left on my Jeep that have not been drilled and something bolted on.” I’m popping 2x of these cans on my TJ over either fender well for my emergency water, 12v. pump, etc. Bravo Zulu. GM

By: angrybob

angrybob — Sun, 12 Jun 2011 23:45:05 +0000

Outstanding article. I just replaced the center console of my ’87 4Runner with the 40mm ammo can. The 40mm version is a perfect fit but I did not want to use an unhinged type. This took all of 20 minutes and about $5 worth of hardware.

I’ll be converting two more so I can keep my recovery tools, etc. locked inside the vehicle without worries.

Thanks for this idea and thanks for your service.

Bob

By: Criss

Criss — Sat, 17 Apr 2010 20:13:19 +0000

Thank you sooo much for this article “A No Weld Solution for Securing Any Two Handle Ammo Can” and “Easily Store Your Ammunition for Decades” both excellent for the “Prepper”, homesteader or survivalist.

Wish I could visit back east and enroll in one or two of your courses.

Keep up the great work!!!!

From a 50 Something, soon to be rural homesteading, Prepper ;-}